1. Ineffective tension:
If the tension is not good, the friction is not good, and then slippage will occur, which will increase the wear of the synchronization belt and other talents that can lose the transmission load. (adding the adhesive synchronous belt) drive instability will cause the belt transmission to lose its effectiveness.
2. Too much tension:
The tension received by the synchronous belt is too high and the deformation is severe, which will reduce the service life of the synchronous belt.
3. There are debris left on the synchronization belt:
If there are dirt such as grease on the synchronous belt, because the dirt contains chemical substances, it can enter the synchronous belt, which will damage its data layout.
4. The synchronization pulley is not aligned:
If the synchronous pulley is not aligned, it will cause the synchronous pulley to slip, distort and heat wear inside, so the synchronous pulley must be aligned.
5. The lengths of the synchronization belt are not equal:
If the lengths of a row of belts are not equal, the size of tension received by each synchronous belt will be different, and some of them will slip or have too much tension, causing the synchronous belt to wear. Therefore, when using it, you must choose the same type of synchronization belt.
6. If the synchronization belt does not operate for a long time, you need to open it, otherwise the service life of the synchronization belt will be reduced and the synchronization belt will be deformed.
7. If the synchronization belt is avoided for too long, it will cause the rubber to age and thus reduce the lifespan.
8. If dust, acid and alkali gas or other gases that will cause Shanghai synchronous belts to be used in the environment on site will also shorten the service life of the synchronous belt.
9. The oscillation is too big:
If the synchronous belt is twitched rapidly due to the machine oscillation, this will cause the synchronous belt to be severely restored, and then reduce the service life.
10., start overload:
When the synchronous belt is operated under overload, it will cause too much tension, causing the synchronous belt to become damaged due to sliding.
11. The wheel grooves of the synchronous pulley are worn:
The synchronous pulley is used for too long, the wear on the edge of the groove is enhanced, and the viewpoint is incorrect. The synchronous belt will touch the bottom end of the groove, which is a femoral machine, and the tension must be increased, resulting in the damage of the triangle belt.

The above content is provided by Jiangyin Chunsheng Tape Co., Ltd., welcome to call for consultation and negotiation.